Large Diameter Impeders

There are various alternatives for larger diameter impeders, personal preference and the application in question will depend somewhat on the selection.For pipe sizes in the 3.5” – 8” range you can use standard through flow impeders with single large ferrites or multiple pieces, these are available up to 152mm outside diameter.

We also offer a range of ‘heavy duty’ versions of these diameter T/flow impeders where higher power and/or low frequency is in operation. Utilising these designs with increased ferrite mass ensures that high power welders are not consuming excessive power from the supply system and good load matching is achieved. Careful design of ferrite positioning also guarantees that the magnetic flux is concentrated in the Welding vee and does not heat up surrounding equipment with stray fields.
A cost effective alternative as pipe diameters increase is an impeder cluster assembly. This consists of a number of individual impeders assembled together into a common manifold which feeds coolant to the impeders. These impeders can be standard round through flow or rectangular configuration and have quick release fittings. Cluster assemblies consist of an aluminium manifold with a clamping system. Also included is a spacer plate to maintain correct alignment of the impeders. Coolant connections are flexible hoses or copper tubing. Return-flow cluster assemblies are available as an option.
EHE rectangular modular impeder clusters can be utilised for larger diameter pipe ranges. A single manifold system can cover a pipe diameter range from 6.625” – 24” OD.  In normal operating conditions the top impeder would require periodic replacement, this impeder can be supplied as exposed ferrite design(as shown) or with a ceramic heat protection pad to increase lifetime
All modular clusters are supplied with quick disconnect fittings to facilitate rapid changing of impeders


Other Products:
Through Flow Impeders
Return Flow Impeders (RFI)
Impeders For Small Diameters